2000 Blazer: How can I replace the turn signal / cruise control level? - cruising signals sauna
If I flash on the left side blinks as it should, but when I step on the brake, the signal is flashing, but not enabled. I have a replacement level, but must know how to remove the parts to get it. I'm happy about the firing of the affected seats.
Monday, February 15, 2010
Cruising Signals Sauna 2000 Blazer: How Can I Replace The Turn Signal / Cruise Control Level?
3 comments:
Oh, they suck a little. I did it before, but it was 5 years ago ... You need the truth about the air bag components, so I do not worry too much. As you can see some plastic panels around the steering column, has a top and bottom. In my experience, this is was the difficult part, I tried out for her. I think the bottom drops, then there are screws that hold you from gaining the upper half (so maybe vice versa). After that is simple enough. Enjoy the three (I think) the screws holding the turn signal, disconnect the new pop and rock and roll. I remember with some Torx bit unusual, so be prepared.
This is not the lever is one of the bulbs or short circuit in the wiring sheet.
that's not his desk, which is the problem. You have a bad ground to the rear taillight.
Post a Comment